Model 2300Installation Guide© 2003 Directed Electronics, Inc. Vista, CA N2300 7-03
10 © 2001 Directed Electronics, Inc. Vista, CAThis system is common in many Toyota, Nissan, Honda, and Saturn models, as well as Fords with the keyles
© 2003 Directed Electronics, Inc. Vista, CA 11
12 © 2001 Directed Electronics, Inc. Vista, CAtype C: reversing polarity system
© 2003 Directed Electronics, Inc. Vista, CA 13Vehicles without factory power door locks require the installation of one actuator per door. This requir
14 © 2001 Directed Electronics, Inc. Vista, CAThis system is found in Mercedes-Benz and Audi 1985 and newer. The door locks are controlled by an elect
© 2003 Directed Electronics, Inc. Vista, CA 15This type of door lock system usually requires a negative pulse to unlock, and cutting the wire to lock
16 © 2001 Directed Electronics, Inc. Vista, CAThis system is most commonly found in Ford, Mazda, Chrysler and GM vehicles. The door lock switch or doo
© 2003 Directed Electronics, Inc. Vista, CA 17The system is most commonly found in Ford, Mazda, Chrysler and GM vehicles. The door lock switch or door
18 © 2001 Directed Electronics, Inc. Vista, CAauxiliary harness (H3) wire connection guide__________________This output is used for progressive door u
1919 © 2001 Directed Electronics, Inc. Vista, CADriver’s Door Unlock Only (Type A):
2 © 2001 Directed Electronics, Inc. Vista, CAtable of contentsAvital®, Bitwriter™, Stealth Coding Technology™, Doubleguard®, ESP™, FailSafe®, Ghost Sw
20 © 2001 Directed Electronics, Inc. Vista, CADriver’s Door Unlock Only (Type B):NOTE: The VIOLET jumper between the #87 lock terminal and the #87 unl
21 © 2001 Directed Electronics, Inc. Vista, CAThis wire supply a (-)200mA output whenever the button(s) controlling channel four is pressed and will c
22 © 2001 Directed Electronics, Inc. Vista, CAplug-in LED and valet/program switchThe LED and the Valet/Program switch both plug into the control modu
©© 2023 © 2001 Directed Electronics, Inc. Vista, CANOTE: For parking light circuits that draw 10 amps or more, the internal jumper must be switchedto
24 © 2001 Directed Electronics, Inc. Vista, CAtransmitter/receiver learn routineThe system comes with two transmitters that have been taught to the re
© 2003 Directed Electronics, Inc. Vista, CA 254. Transmit. While HOLDING the Valet®/Program switch, press the transmitter button that youwish to assig
26 © 2001 Directed Electronics, Inc. Vista, CAtransmitter configurationThe standard 4-button transmitters can be programmed in one step by using the A
© 2003 Directed Electronics, Inc. Vista, CA 274. Transmit. While HOLDING the Valet®/Program switch, you can select the desired featuressetting using t
28 © 2001 Directed Electronics, Inc. Vista, CAfeatures menufeature descriptions1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system wi
© 2003 Directed Electronics, Inc. Vista, CA 29accommodate door lock interface in these vehicles. The default setting is 0.8 second door lock pulses. S
© 2003 Directed Electronics, Inc. Vista, CA 3what is included The control module Two 4-button remote transmitters The plug-in LED system status i
30 © 2003 Directed Electronics, Inc. Vista, CAtable of zonesWhen using the Diagnostic functions, use the Table of Zones to see which input has trigger
© 2003 Directed Electronics, Inc. Vista, CA 31 Door input does not respond with the progressive trigger, but with immediate full alarm:Does the LED i
32 © 2001 Directed Electronics, Inc. Vista, CAwiring quick reference diagram
© 2003 Directed Electronics, Inc. Vista, CA 33
4 © 2001 Directed Electronics, Inc. Vista, CAAs shipped, this wire should be connected to the (+) parking light wire. If the light flash polarity jump
© 2003 Directed Electronics, Inc. Vista, CA 5Connect this wire directly to the domelight circuit in the vehicle. The on-board relay will drive circuit
6 © 2001 Directed Electronics, Inc. Vista, CAThis wire is used in vehicles that have a positive (+) switched domelight circuit. Connect the violet wir
© 2003 Directed Electronics, Inc. Vista, CA 7Before connecting this wire, remove the supplied fuse. Connect to the positive battery terminal or the co
8 © 2001 Directed Electronics, Inc. Vista, CAdoor lock harness (H2) wire connection guide__________________________________________*VIOLET and VIOLET/
© 2003 Directed Electronics, Inc. Vista, CA 9you can usually simplify the installation by locating the same wires in the vehicle’s kick panel. If no c
Kommentare zu diesen Handbüchern